My Car Quest

October 14, 2019

Bizzarrini GT 5300 Body For Sale – And SOLD!

This rare Bizzarrini GT 5300 Body has SOLD.

Congratulations to buyer and seller.

 

Bizzarrini GT 5300 Body For Sale

Bizzarrini GT 5300 Body

This is a hand built fiberglass body, for a Bizzarrini GT 5300 Strada or GT America, for sale to the highest bidder.

It is made with tooling resin, which is 40% stronger than laminating resin, and reinforced with roving fiberglass cloth, which is about 10 times stronger than conventional matt and bi-directional cloths.

Photos with the doors included will be available soon.

Bizzarrini GT 5300 Body

Bizzarrini GT 5300 Body

Bizzarrini GT 5300 Body

Bizzarrini GT 5300 Body

Bizzarrini logo

My Car Quest provides no warranty about the content or accuracy of the content published here. My Car Quest shall not be liable for any loss of profit or any other damages resulting from use of the information published here. Descriptions and content of advertisements are the sole liability and responsibility of the individual seller.

Comments

  1. where would one get the glass?

  2. wallace wyss says

    There is a firm in Orange County called Metalcrafters. They make prototypes for carmakers. They have a machine
    that only needs the measurements and it will make a windscreen. Of course it may not meet DOT standards but since it’s only prototype that doesn’t matter. I might cost several thousand but hey, even a stock windshield for a race car can cost a $1000. Try them and see, they may go months without using the machine.

  3. Mike Clarke says

    This is actually not a body but whats known as a plug. It is what is used to make a mold with. One of the giveaways are those two big posts that are laminated in the center, this is to keep the roof rigid while the fiberglass is being laminated over it.. Plugs and molds use tooling resin because it’s strong and rigid….but heavy. So to get a body you would have to make a mold using gelcoat as your first layer, then multiple layers of glass, once this is done with the glass still on the plug you laminate stiffeners, they’re made out of plywood or more fiberglass, once the stiffeners are laminated on you can pull the molds off, reassemble the mould and start the process over again using gelcoat and then glass. After thats done you can pop the body out of the mold.

    • You are wise.. One million thanks yous,

      • SKIP HINOJOS says

        EXCUSE ME !!! THIS IS SKIP HINOJOS, TH E MAKER OF THIS BODY AND THREE OTHERS. IT IS A BODY, AND CAN BE USED AS A PLUG, IF SOMEONE WANTS TO MAKE A MODE, TO RECREATE MORE BODIES. LIKE THE MAN SAID …. A LITTLE KNOWLEDGE CAN BE A DANGEROUS THING.

  4. Skip as the maker of the body you can call it whatever you want

Speak Your Mind

*

fsge6ed6.txt